Dell Inspiron 530s (Mid 2007) - Manual (Page 127)

Removing and Installing Parts
127
4 Insert the module into the connector until the module snaps into position.
If you insert the module correctly, the securing clips snap into the cutouts
at each end of the module.
5 Replace the PCI Express x16 card. See "Cards" on page 128.
6 Replace the computer cover.
NOTICE:
To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
7 Connect your computer and devices to electrical outlets, and turn them on.
8 Right-click the My Computer icon and click Properties.
9 Click the General tab.
10 To verify that the memory is installed correctly, check the amount of
memory (RAM) listed.
Removing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
CAUTION:
Before removing memory, you must remove the PCI Express x16 card.
See "Cards" on page 128.
NOTICE:
To prevent static damage to components inside your computer, discharge
static electricity from your body before you touch any of your computer’s electronic
components. You can do so by touching an unpainted metal surface on the
computer chassis.
1 Follow the procedures in "Before You Begin" on page 103.
2 Press out the securing clip at each end of the memory module connector.
3 Grasp the module at the end of the board and lift up.
4 Replace the PCI Express x16 card. See "Cards" on page 128.
book.book Page 127 Monday, October 6, 2008 11:38 AM