Dell OptiPlex G1 - Manual (Page 135)

ISA Configuration Utility Messages B-1
$ 3 3 ( 1 ' , ;  %
,6$&RQILJXUDWLRQ8WLOLW\
0HVVDJHV
The ISA Configuration Utility (ICU) and its Configuration Manager are capable of iden-
tifying problems and alerting you to them. Both utilities can alert you to problems with
card configuration as well as problems that prevent proper operation of the utility. This
appendix describes each type of message and lists the possible causes and actions
you can take to resolve any problems indicated by a message. See the following
tables to locate your message and identify any possible corrective actions.
,&8(UURU0HVVDJHV
The ICU can display a variety of error messages while in operation. These messages
alert you to problems that prevent the ICU from running correctly, as well as informing
you of resource conflicts that prevent the configuration of various cards in your com-
puter. If you receive a message from the ICU, see Table B-1 for suggestions on
resolving any problems indicated by the message.
7DEOH%&RQILJXUDWLRQ8WLOLW\0HVVDJHV
0HVVDJH 3UREDEOH&DXVH &RUUHFWLYH$FWLRQ
2XWRIPHPRU\
0HPRU\DOORFDWLRQ
IDLOHG
Either of these messages
can appear if the system
runs out of memory dur-
ing operation of the
utility. Disable any TSR programs or any unneeded device
drivers.
1RWHQRXJKPHPRU\
WRUXQWKH,&8
This message appears
when you start the ICU if
the system does not
have enough memory to
run the utility.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.