Table 5-1, System-board jumper settings -10 – Dell OptiPlex G1 User Manual
Page 90
5-10
Dell OptiPlex G1 Mini Tower Managed PC Reference and Installation Guide
7DEOH6\VWHP%RDUG-XPSHU6HWWLQJV
-XPSHU
6HWWLQJ
'HVFULSWLRQ
PSWD
Password features are enabled.
Password features are disabled.
BIOS
Reserved
(do not change).
BUS66M
Reserved
(do not change).
266MHZ
*
Jumpered when the microprocessor’s internal
speed is 266 MHz.
300MHZ
*
Jumpered when the microprocessor’s internal
speed is 300 MHz.
333MHZ
*
Jumpered when the microprocessor’s internal
speed is 333 MHz.
350MHZ
*
Jumpered when the microprocessor’s internal
speed is 350 MHz.
400MHZ
*
Jumpered when the microprocessor’s internal
speed is 400 MHz.
450MHZ
*
Jumpered when the microprocessor’s internal
speed is 450 MHz.
RSVD1
Reserved
(do not change).
*
One set of the speed jumper pins must have a jumper plug installed; otherwise, the system
will operate at an undetermined speed.
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in your
online System User’s Guide.
(default)
(default)
(default)
jumpered
unjumpered