Dell OptiPlex G1 - Manual (Page 42)

2-8 Dell OptiPlex G1 Mini Tower Managed PC Reference and Installation Guide
'LVNHWWH'ULYH$
Selecting Diskette Drive A: as the first device causes the system to try booting
from drive A first. If the system finds a diskette that is not bootable in the drive or
finds a problem with the drive itself, it displays an error message. If it does not
find a diskette in the drive, the system tries to boot from the hard-disk drive (drive
0), then from the CD-ROM drive, and finally from the Plug and Play network
adapters in the order found.
+DUG'LVN'ULYH

Selecting Hard Disk Drive causes the system to attempt to boot first from the
hard-disk drive and then from the Plug and Play network adapters in the order
found.
,'(&'5205HDGHU
Selecting IDE CD-ROM Reader causes the system to try booting from the
CD-ROM drive first. If the system finds a CD that is not bootable in the drive or
finds a problem with the drive itself, it displays an error message. If it does not
find a CD in the drive, the system tries to boot from drive A, then from drive C,
and finally from the Plug and Play network adapters in the order found.
2QERDUG1,&
Selecting Onboard NIC causes the system to try booting from the integrated net-
work interface controller (NIC) first.
6\VWHP0HPRU\
System Memory indicates the entire amount of installed memory detected in your
system, except for memory on Expanded Memory Specification (EMS) expansion
cards. After adding memory, check this category to confirm that the new memory is
installed correctly and is recognized by the system.
9LGHR0HPRU\
Video Memory displays the amount of video memory detected in your system.
5HVHUYHG0HPRU\
Reserved Memory allows you to designate a region of system board memory that
can be supplied by an expansion card. You should not enable the reserved memory
feature unless you are using an expansion card that requires special addressing.
For example, you may have a memory expansion card that needs to be addressed
starting at 15 MB. Selecting the 15M - 16M
option in the Reserved Memory category
specifies that the base memory from 15 to 16 MB come from the memory expansion
card (the base memory below the 15-MB address comes from the dual in-line mem-
ory modules [DIMMs] on the system board).