Dell OptiPlex G1 - Manual (Page 139)

ISA Configuration Utility Messages B-5
7KHFRQILJXUDWLRQ
FIJ ILOHXVHG
E\WKH,&8IRU
WKLVFDUGLVQRZ
LQYDOLGRUGRHV
QRWH[LVW'R\RX
ZLVKWRORDGWKH
ILOH"
1RFRQILJXUDWLRQ
FIJ ILOH
H[LVWVIRUWKH
FDUGEHLQJPRGL
ILHG'R\RXZDQW
WRORDGRQH"
This message appears
when you try to add a
listed card and the config-
uration file for this card
has been corrupted or
deleted from the data-
base.
This message appears
when you modify a card
and its configuration file
does not exist or has
been deleted.
You can get a copy of the configuration file from
the original
ISA Configuration Utility Diskette that
you used to create the backup ICU diskette. Use
the following procedure:
 ,QVHUWWKHRULJLQDO,6$&RQILJXUDWLRQ
8WLOLW\'LVNHWWHLQWRGULYH$
 &KDQJHWRWKHGEVXEGLUHFWRU\RQWKHGLV
NHWWHGULYH
For example, type cd
D ?GE.
 8VHDWH[WHGLWRUWRVHDUFKWKHLFXQG[ILOH
IRUWKHFDUG,'RIWKHFDUG\RXZDQWWRDGG
RUPRGLI\
The name of the configuration file is part of
this card ID. For example, if the card ID is
ICU0200, the configuration file is !icu0200.cfg.
 &RS\WKHFRQILJXUDWLRQILOHIURPWKH
RULJLQDO,&8GLVNHWWHWRWKHEDFNXS
GLVNHWWH
7KLVLVDQ(,6$
V\VWHP8VHDQ
(&8QRWWKH,&8
WRFRQILJXUH\RXU
V\VWHP
This message appears if
you attempt to run the
ICU on an EISA system. To use the ICU, you must load the utility onto a
non-EISA system.
7DEOH%&RQILJXUDWLRQ8WLOLW\0HVVDJHV FRQWLQXHG
0HVVDJH 3UREDEOH&DXVH &RUUHFWLYH$FWLRQ
NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary in the online System User’s Guide.