Dell Latitude D510 - Manual (Page 13)

9. Remove the four M2.5 x 5-mm screws.
10. Rotate the display assembly to a 90-degree angle, and lift the display assembly up and out of the computer base.
Display Bezel
1. Follow the instructions in " Preparing to Work Inside Your Computer ."
1 display cable
2 display cable connector on system board
3 antenna cables (2)
4 antenna securing clips (2)
1 M2.5 x 5-mm screws (4)
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's
electronic components. You can do so by touching an unpainted metal surface.