Removing the hard drive from its carrier, Remove the old hard drive from its carrier, And attach the carrier to the new hard drive – Dell Latitude D510 User Manual

Page 20

Advertising
background image

 

2.

Ensure that the display is open approximately 2.54 cm (1 inch).

 

3.

Press the hard drive cover into the bay until it is fully seated in the bay.

 

4.

Turn the computer upside down. Use a small screwdriver to tighten the screws.

 

5.

Install the operating system for your computer.

 

6.

Install the drivers and utilities for your computer.

 

Removing the Hard Drive From Its Carrier

 

 

 

1.

Remove the two screws labeled M2 x 3.

 

2.

Use spring tension to gently pry the carrier open near the back of the carrier.

 

3.

Lift the hard drive out of the carrier.

Back to Contents Page

 

NOTICE:

Use firm and even pressure to slide the drive into place. If you force the hard drive into place using excessive force, you may damage the

connector.

CAUTION:

If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.

CAUTION:

Before working inside your computer, read the safety instructions in your Product Information Guide.

NOTICE:

Hard drives are extremely fragile; even a slight bump can damage the drive.

1

M2 x 3 screws (2)

2

hard drive carrier

3

hard drive

Advertising