Dell Latitude D510 - Manual (Page 33)

Back to Contents Page
Microprocessor Thermal-Cooling Assembly
Dell™ Latitude™ D510 Service Manual
Removing the Microprocessor Thermal-Cooling Assembly
Installing the Microprocessor Thermal-Cooling Assembly
Removing the Microprocessor Thermal-Cooling Assembly
1. Follow the instructions in " Preparing to Work Inside Your Computer ."
2. Remove the keyboard .
3. Remove the captive screw that attaches the display cable to the system board.
4. Disconnect the display cable from the display cable connector on the system board.
5. Release the display cable from its routing clips and slide it out from beneath the tab on the palm rest.
6. Release the two antenna cables from the two antenna-securing clips.
7. Disconnect one antenna cable from the display by holding the two gold antenna connectors and gently pulling them apart. Then disconnect the other
antenna cable. (The gold antenna connectors on each cable are keyed to ensure that they are correctly reconnected.)
8. In consecutive order, loosen the four captive screws labeled "1" through "4," that secure the microprocessor thermal-cooling assembly to the system
board.
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's
electronic components. You can do so by touching an unpainted metal surface.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
1 display cable connector
2 display cable connector on system board
3 captive screw
4 antenna cables (2)
5 antenna connectors (2)