System board, Removing the system board – Dell Latitude D510 User Manual
Page 30
Back to Contents Page
System Board
Dell™ Latitude™ D510 Service Manual
Removing the System Board
The system board's BIOS chip contains the Service Tag, which is also visible on a barcode label on the bottom of the computer. The replacement kit for the
system board includes a CD that provides a utility for transferring the Service Tag to the replacement system board.
1.
Follow the instructions in "
Preparing to Work Inside Your Computer
."
2.
Remove the
palm rest
.
3.
Remove the
microprocessor thermal-cooling assembly
.
4.
Remove the
microprocessor
.
5.
Remove the
speakers
.
6.
Remove the two M2.5 x 5-mm screws labeled "B".
7.
Turn the computer upside down and remove the four M2 x 3-mm screws labeled "B" that secure the system board to the computer base.
CAUTION:
Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE:
Disconnect the power supply and any attached devices from electrical outlets, and remove any installed batteries.
NOTICE:
To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's
electronic components. You can do so by touching an unpainted metal surface.
1 M2.5 x 5-mm screws (2)
2 system board