Dell PowerVault MD1220 - Manual (Page 41)

Installing Enclosure Components
41
Installing a Power Supply/Cooling Fan Module
1 Slide the power supply/cooling fan module into the chassis until it is fully
seated and the release tab clicks into place. See Figure 3-9.
2 Connect the power cable to the power supply/cooling fan module and plug
the cable into a power outlet.
3 Secure the power cable using the Velcro strap. See Figure 3-10.
Figure 3-10. Securing the Power Cable
CAUTION:
When connecting the power cable, secure the cable with the Velcro
strap.
NOTE:
If the enclosure is powered on, all the power supply LEDs remain off until
the AC power cable is connected to the power supply/cooling fan module and the
power switch is turned on.
4 Turn on the power supply/cooling fan module.
1 Velcro strap
1
book.book Page 41 Monday, December 7, 2009 4:51 PM