Dell 7330dn Mono Laser Printer - Manual (Page 52)

UNIX (Linux)
Dell 7330 Mono Laser Printer
3-23
UNIX (Linux)
Your printer supports connection to a variety of UNIX platforms through the parallel and
network interface. The workstations currently supported by EWS for UNIX/Linux to a
network-connected printer are:
■ Sun Solaris
■ HPUX 11.0
■ HPUX 11i
■ AIX 5.0
■ Linux (i86)
The following procedures enable you to connect your printer using any of the supported
versions of UNIX or Linux listed above.
Quick Install Steps
Perform the following procedures to set up the printer and install the appropriate drivers.
From the Printer
To set up the printer:
1. Verify that both TCP/IP protocol and the proper connector are enabled.
2. On the control panel, select one of these IP address options:
■ Allow the printer to set up a DHCP address.
■ Enter the IP address manually.
3. Print the Configuration page and keep it for reference.