Dell Inspiron 9300 - Manual (Page 32)

Back to Contents Page
Coin-Cell Battery
Dell™ Inspiron™ 9300 Service Manual
Removing the Coin-Cell Battery
Replacing the Coin-Cell battery
Removing the Coin-Cell Battery
1. Follow the instructions in " Before Working Inside Your Computer ."
2. Remove the hinge cover .
3. Remove the keyboard .
4. Remove the existing coin-cell battery:
a. Disconnect the battery cable connector from the system board.
b. Press the release latch on the side of the coin-cell battery compartment, and lift up the battery.
Replacing the Coin-Cell battery
1. Install the replacement battery:
a. With the positive side up, insert the battery at a 30-degree angle under the release latch, and then push the battery into place.
b. Connect the battery cable to the connector on the system board.
2. Replace the keyboard .
3. Replace the hinge cover .
CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
NOTE: You may experience slight resistance when you lift the battery because of an adhesive underneath the battery that holds it in place.
1 coin-cell battery
2 release latch
3 battery cable connector