System board connectors, Scsi backplane board connectors, Table a-1 – Dell PowerEdge 2500SC User Manual
Page 3
Table A-1. System-Board Jumper Settings
System Board Connectors
See
Figure 6-1
and
Table 6-1
for the location and description of system board connectors.
SCSI Backplane Board Connectors
shows the location of the connectors on the back of the SCSI backplane board.
Figure A-3. Connectors on the SCSI Backplane Board
Jumper
Setting
Description
PASSWD
(default) The password feature is enabled.
The password feature is disabled.
NVRAM_CLR
(default) The configuration settings are retained at system boot.
The configuration settings are cleared at next system boot. (If the configuration settings become corrupted to the point where
the system will not boot, install the jumper plug and boot the system. Remove the jumper before restoring the configuration
information.)
ONCE
Reserved (do not change).
jumpered
unjumpered
NOTE:
For the full name of an abbreviation or acronym used in this table, see "Abbreviations and Acronyms."