4 create a bootable virtual disk, C select continue to boot and press <enter – Dell PowerEdge RAID Controller S100 User Manual
Page 40
40
Installing the Drivers
4
Create a bootable
virtual disk
See "Creating Virtual Disks" on page 51.
5
Check controller
options and the boot
list priority
a
At the PERC S100 Virtual Disk Management utility or
PERC S300 Virtual Disk Management utility, use the
arrow keys to select Controller Options. Press
<Enter>. Make sure that Toggle INT13 Boot
Support is ON. Press <Esc> to exit.
b
At the Virtual Disks field, make sure the bootable
virtual disk created in Procedure 4, is the first virtual
disk listed.
If the bootable virtual disk is not the first virtual disk
listed, see "Swapping Two Virtual Disks" on page 55.
NOTE:
If Non-Raid virtual disks are used (and appear in the
Virtual Disks list), the Swap Two Virtual Disks option
is enabled only if the system contains an initialized physical
disk.
c
Select Continue to Boot and press <Enter>.
NOTE:
If the next Procedure (6) is not applicable, continue
with one of the following procedures:
• "Installing the Controller Drivers During the Operating
System Installation: For Systems with a PERC S100
• "Installing the Controller Drivers During the Operating
System Installation: For Systems with a PERC S300
Table 5-2. Pre-Installation Procedures For The Controller Drivers
(continued)
Procedure
Steps
A5_bk0.book Page 40 Thursday, February 10, 2011 8:34 PM