Dell PowerEdge 6600 - Manual (Page 49)

Back to Contents Page
Installing System Options
Dell™ PowerEdge™ 6600 Systems Installation and Troubleshooting Guide
This section describes how to install the following options:
l Expansion cards
l Memory upgrades
l Microprocessor upgrades
This section also includes instructions for replacing:
l Fans
l I/O riser card
l Peripheral riser card
l Power supplies
l System battery
Fan Assembly Tray
The system includes a fan assembly tray containing six fans. The fans can be removed as an assembly or individually.
Removing the Fan Assembly Tray
1. Remove the back cover (see " Removing the Back Cover " in "Troubleshooting Your System").
2. Remove the front cover (see " Removing the Front Cover " in "Troubleshooting Your System").
3. Using the fan assembly tray handles, lift the assembly straight up to clear the chassis (see Figure 6 -1 ).
Replacing the Fan Assembly Tray
1. Align the alignment tabs with the slots in the chassis (see Figure 6 -1 ).
2. Lower the fan assembly tray into the chassis.
3. Ensure that the fans are fully seated.
4. Replace the front cover (see " Replacing the Front Cover " in "Troubleshooting Your System").
5. Replace the back cover (see " Replacing the Back Cover " in "Troubleshooting Your System").
Figure 6-1. Removing the Fan Assembly Tray
Fan Assembly Tray
Power Supplies
AC Power Module
Expansion Cards
Peripheral Riser Card
I/O Riser Card
Memory Riser Cards
Memory Modules
Microprocessor Tray
Microprocessors
System Battery
CAUTION: Before you perform these procedures, you must turn off the system and disconnect it from its power source. For more information, see
" Safety First—For You and Your System " in "Troubleshooting Your System."
NOTICE: Ensure that the memory riser card handles and the peripheral riser card handles are in the closed position before installing the fan assembly
tray.