Dell Inspiron 3000 - Manual (Page 45)

Removing and Replacing Parts 4-9
Z
IF Connectors
Some of the computer’s interface connectors are zero insertion force (ZIF)
connectors. These connectors are not removable; they must be released to
disconnect a cable from them.
To disconnect a cable from a ZIF connector, follow these steps:
1. Insert a small flat-blade screwdriver or dental pick under the movable part
of the connector (see Figure 4-10).
For most ZIFs, carefully pry up first one end of the movable part of the con-
nector and then the other end. Some ZIFs (keyboard connector on the main
board) may need to be lifted in the center.
.
Figure 4-10. Releasing a ZIF Connector
2. Pull up gently on the movable part of the connector until the cable is
released.
3. Grasp the cable and pull it out of the connector.
To reconnect an interface cable to a ZIF connector, follow these steps:
1. Use the flat-blade screwdriver to open the movable part of the ZIF
connector.
2. Orient the end of the cable with the ZIF connector, and insert the end of the
cable into the connector.
3. While holding the cable in place, close the ZIF connector.
To ensure a firm connection, make sure the ZIF connector is completely
closed.
CAUTION: ZIF connectors are fragile. To avoid breaking the connec-
tors, touch them carefully. Do not apply too much pressure to the
movable part of the connector when opening or closing it.