Dell Inspiron 3000 - Manual (Page 72)

4-36 Dell Inspiron 3000 Series Service Manual
S
tatus Display Panel
Figure 4-22. Status Display Panel Removal
To remove the status display panel, follow these steps:
1. Remove the hinge covers and connector cover.
See “Keyboard” found earlier in this chapter.
2. Remove status display panel screw SD1.
3. Remove the status display panel.
The status display panel has two connectors.
4. Disconnect the status display panel connector from connector JP5 on the
main board.
5. Disconnect the I/R cable from connector P3 on the status display panel.
6. Remove the status display panel from the palmrest assembly.
When reinstalling the status display panel, see the first Caution for “Keyboard”
found earlier in this chapter.
(screw SD1 is 5 mm)
5 mm
SD1
status display panel
status display panel
connector
I/R cable
palmrest
assembly
connector P3
connector JP5