Dell PowerEdge 850 User Manual
Page 95
Error 8602: Auxiliary device failure.
Verify that mouse and keyboard are
securely attached to correct
connectors.
Loose or improperly connected mouse or
keyboard cable; faulty mouse or keyboard.
Replace the mouse. If the problem persists, replace the
keyboard.
Gate A20 failure
Faulty keyboard controller (faulty system board). See "
Getting Help
."
General failure
The operating system is unable to carry out the
command.
This message is usually followed by specific information. Take
the appropriate action to resolve the problem.
IDE Primary drive 0 not found
Primary drive 0 set as Auto, no disk.
Run the System Setup program to correct the settings. See
"Using the System Setup Program" in your User's Guide.
Invalid memory configuration detected.
Potential for data corruption exists!
Unsupported DIMMs are installed in the system,
or the memory configuration is incorrect.
Replace or reconfigure the DIMMs. See "
System Memory
" in
"Installing System Components" for memory configuration
guidelines, a list of supported DIMMs, and supported memory
configurations.
Keyboard controller failure
Faulty keyboard controller (faulty system board). See "
Getting Help
."
Keyboard data line failure
Keyboard failure
Keyboard stuck key failure
Loose or improperly connected keyboard cable;
faulty keyboard; faulty keyboard controller.
Ensure that the keyboard is properly connected. If the
problem persists, replace the keyboard. If the problem
persists, see "
Getting Help
."
Keyboard fuse has failed.
Keyboard fuse has failed.
Replace the keyboard.
Faulty system board.
If the problem persists, the system board is faulty. See
"
Getting Help
."
Manufacturing mode detected
System is incorrectly configured.
Memory address line failure at address,
read value expecting value
Memory double word logic failure at
address, read value expecting value
Memory odd/even logic failure at start
address to end address
Memory write/read failure at address,
read value expecting value
Faulty or improperly installed memory modules,
or faulty system board.
Ensure that all memory modules are properly installed. See
"
Troubleshooting System Memory
" in "Troubleshooting Your
System." If the problem persists, see "
Getting Help
."
Memory tests terminated by keystroke
The spacebar was pressed during POST to
terminate the memory test.
Information only.
No boot device available
The system cannot find the diskette or hard
drive.
If the diskette drive is your boot device, ensure that a
bootable disk is in the drive.
If the hard drive is your boot device, ensure that the hard
drive is installed, properly seated, and partitioned as a boot
device.
Enter the System Setup program and verify the boot
sequence information. See your User's Guide for details.
No boot sector on hard-disk drive
The system configuration information in the
System Setup program might be incorrect.
Enter the System Setup program and verify the system
configuration information for the hard drive. See your User's
Guide for details.
If the message continues to appear after verifying the
information in the System Setup program, the operating
system might have been corrupted. Reinstall the operating
system. See your operating system documentation for
reinstallation information.
No timer tick interrupt
A chip on the system board might be
malfunctioning.
Run the system diagnostics. See "
Running the System
Diagnostics
."
Not a boot diskette
The operating system is trying to boot from a
diskette that does not have a bootable
operating system installed on it.
Insert a diskette that has a bootable operating system.
PCI BIOS failed to install
PCI device BIOS (Option ROM) checksum failure
is detected during shadowing.
Ensure that all appropriate cables are securely connected to
the expansion cards. If the problem persists, see
"
Troubleshooting Expansion Cards
" in "Troubleshooting Your
System."
PCIe Degraded Link Width Error:
Embedded Bus#nn/Dev#nn/Funcn
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed PCIe card.
Reseat the PCIe cards. See "
Expansion Cards
" in "Installing
System Components." If the problem persists, see "
Getting
Help
."
PCIe Degraded Link Width Error: Slot n
Expected Link Width is n
Actual Link Width is n
Faulty or improperly installed PCIe card in the
specified slot number.
Reseat the PCIe card in the specified slot number. See
"
Expansion Cards
" in "Installing System Components." If the
problem persists, see "
Getting Help
."
PCIe Training Error: Embedded
Bus#nn/Dev#nn/Funcn
Faulty or improperly installed PCIe card.
Reseat the PCIe cards. See "
Expansion Cards
" in "Installing
System Components." If the problem persists, see "
Getting
Help
."
PCIe Training Error: Slot n
Faulty or improperly installed PCIe card in the
specified slot number.
Reseat the PCIe card in the specified slot number. See
"
Expansion Cards
" in "Installing System Components." If the