Password (user exec), Show authentication methods, Password – Dell POWEREDGE M905 User Manual
Page 138
104
AAA Commands
www
.dell.com | support.dell.com
password
(User EXEC)
Use the password command in User EXEC mode to allow a user to change the password for only
that user. This command should be used after the password has aged. The user is prompted to
enter the old password and the new password.
Syntax
password
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example shows the prompt sequence for executing the password command.
console>password
Enter old password:********
Enter new password:********
Confirm new password:********
show authentication methods
Use the show authentication methods command in Privileged EXEC mode to display information
about the authentication methods.
Syntax
show authentication methods
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.