Maximum-paths, Redistribute – Dell POWEREDGE M905 User Manual
Page 735
OSPFv3 Commands
741
User Guidelines
This command has no user guidelines.
Example
Use the following command to enable OSPFv3.
console(config)#ipv6 router ospf
maximum-paths
Use the maximum-paths command in Router OSPFv3 Configuration mode to set the number of
paths that OSPF can report for a given destination.
Syntax
maximum-paths maxpaths
no maximum-paths
•
maxpaths—Number of paths that can be reported. (Range: 1-2)
Default Configuration
2 is the default value for maxpaths.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of paths that OSPF can report for a given destination
to 1.
console(config)#ipv6 router ospf
console(config-rtr)#maximum-paths 1
redistribute
Use the redistribute command in Router OSPFv3 Configuration mode to configure the OSPFv3
protocol to allow redistribution of routes from the specified source protocol/routers.