Enable, Hostroutesaccept – Dell POWEREDGE M905 User Manual
Page 784
792
Routing Information Protocol (RIP) Commands
www
.dell.com | support.dell.com
User Guidelines
This command has no user guidelines.
Example
The following example elects access list ACL40 to filter routes received from the source
protocol.
console(config-router)#distribute-list ACL40 out static
enable
Use the enable command in Router RIP Configuration mode to reset the default administrative
mode of RIP in the router (active). Use the no form of the command to disable the administrative
mode for RIP.
Syntax
enable
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router RIP Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config-router)#enable
hostroutesaccept
Use the hostroutesaccept command in Router RIP Configuration mode to enable the RIP
hostroutesaccept mode. Use the no form of the command to disable the RIP
hostroutesaccept mode.
Syntax
hostroutesaccept
no hostroutesaccept