Replacing the status light board – Dell Alienware M11x R2 (Mid 2010) User Manual
Page 29
Replacing the Status Light Board
1.
Follow the instructions in
Before You Begin
.
2.
Place the status light board on the palm rest assembly and replace the five screws that secure the status light board to the palm rest assembly.
3.
Connect the speaker lights cable to the connector on the status light board.
4.
Insert the status light board cable into the connector on the status light board and press the connector latch into the connector to secure the cable.
5.
Insert the power board cable into the connector on the status light board and press down on the connector latch to secure the cable.
6.
Replace the palm rest assembly (see
Replacing the Palm Rest Assembly
).
7.
Replace the keyboard (see
Replacing the Keyboard
).
8.
Replace the hinge cover (see
Replacing the Hinge Cover
).
9.
Replace the memory module(s) (see
Replacing the Memory Module(s)
).
10.
Follow the instructions from
step 6
to
step 8
in
Replacing the Hard Drive
.
11.
Replace the battery pack (see
Replacing the Battery Pack
).
12.
Replace the base cover (see
Replacing the Base Cover
).
Back to Contents Page
1
status light board
2
screws (5)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.