Palm rest assembly, Removing the palm rest assembly – Dell Alienware M11x R2 (Mid 2010) User Manual
Page 34
Back to Contents Page
Palm Rest Assembly
Alienware® M11x R2 Service Manual
Removing the Palm Rest Assembly
Replacing the Palm Rest Assembly
Removing the Palm Rest Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the base cover (see
Removing the Base Cover
).
3.
Remove the battery pack (see
Removing the Battery Pack
).
4.
Follow the instructions from
step 4
to
step 6
in
Removing the Hard Drive
.
5.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
6.
Remove the nine screws that secure the palm rest to the computer base.
7.
Turn the computer over and open the display as far as possible.
8.
Remove the hinge cover (see
Removing the Hinge Cover
).
9.
Remove the keyboard (see
Removing the Keyboard
).
10.
Lift the connector latches and pull the pull-tabs to disconnect the touch pad cable and status light board cable from their connectors on the system
board.
11.
Remove the three screws that secure the palm rest assembly to the computer base.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery Pack
) before working inside the
computer.
CAUTION:
Pull the pull-tabs on top of the connectors to avoid damage to the connectors.