Dell 1133 Laser Mono Printer - Manual (Page 45)

Do not use transparencies that separates from the backing sheet.
To prevent transparencies from sticking to each other, do not let the printed sheets stack up as they are being
printed out.
Labels
To avoid damaging the machine, use only labels designed for use in laser machines.
When selecting labels, consider the following factors:
Adhesives: The adhesive material should be stable at your machine’s fusing temperature of about 170
°C (338 °F).
Arrangement: Only use labels with no exposed backing between them. Labels can peel off sheets that
have spaces between the labels, causing serious jams.
Curl: Prior to printing, labels must lie flat with no more than 13 mm of curl in any direction.
Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
Make sure that there is no exposed adhesive material between labels. Exposed areas can cause labels to peel
off during printing, which can cause paper jams. Exposed adhesive can also cause damage to machine
components.
Do not run a sheet of labels through the machine more than once. The adhesive backing is designed for only a
single pass through the machine.
Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or otherwise damaged.
Card stock/Custom-sized paper
Postcards, cards, and other custom-sized materials can be printed with this machine.
Do not print on media smaller than 76 mm (3.00 inches) wide or 127 mm (5.00 inches) long.
In the software application, set margins at least 6.4 mm (0.25 inches) away from the edges of the material.
If media weight is over 160 g/m
2
(43 lb), try printing in the rear cover (face up).
Letterhead/ Preprinted paper
Single-sided Double-sided
Tray1 Face down Face up
Manual tray Face up Face down