Dell 1133 Laser Mono Printer - Manual (Page 7)

life, which indicates the average capacity
of print-outs and is designed pursuant to
ISO/IEC 19752 (See
Available supplies ).
The number of pages may be affected by
operating environment, printing interval,
media type, and media size. Some
amount of toner may remain in the
cartridge even when End of life
Replace new cart appears and the
printer stops printing.
Error [error
number]
Turn off
then on A systematic error has occurred Reboot the power and try the printing job again. If
the problem persists, call for service.
Install
Toner The toner cartridge is installed improperly,
or not installed. Reinstall the toner cartridge two or three times to
confirm it is seated properly. If the problem persists,
the toner cartridge is not being detected. Contact the
service representatives.
Load
[media size]
in
[tray
number] There is no corresponding paper in the
corresponding tray. Load corresponding paper in the corresponding tray
(See
Loading paper in the tray ).
Not
Compatible
toner
cartridge The toner cartridge is not suitable for your
machine. Install the corresponding toner cartridge with a Dell-
genuine cartridge (See
Replacing the toner cartridge ).
Output bin
Full
Remove
paper The output tray is full. Or the sensor is not
facing down. Remove papers from the output tray, the machine
resumes printing. Or make sure the sensor is facing
down. If the problem persists, call for service.
Paper
Empty
in [tray
number] There is no paper in the indicated tray. Load paper in the tray (See Loading paper in the
tray ).
Pulled Out
[tray
number]
Cassette The indicated tray cassette is not inserted,
or not properly closed. To close the tray, lower the rear edge, align it with
the slot, and slide it into the printer.
Paper Jam
in MP Tray Paper has jammed in the manual tray area. Clear the jam (See In the manual tray ).
Paper Jam
in Tray 1 Paper has jammed in the tray1 area. Clear the jam (See In tray 1 ).
Paper Jam
inside
machine Paper has jammed inside the machine. Clear the jam (See Inside the machine ).
Paper Jam
in exit area Special print media has jammed in the paper
exit area. Clear the jam.
See In exit area .
See In the manual tray )
Prepare
new
cartridge Small amount of toner is left in the indicated
cartridge. The estimated cartridge life of
toner is close. Prepare a new cartridge for a replacement. You may
temporarily increase the printing quality by
redistributing the toner (See
Redistributing toner ).
Remove
seal tape
&Install
Toner The machine cannot detect a toner
cartridge. Remove the sealing tape from the toner cartridge.
Refer to Quick Install Guide.
Replace
Toner The toner cartridge has almost reached its
estimated cartridge life. You can choose between Stop or Continue as shown
on the control panel. If you select Stop, the printer
stops printing and you cannot print any more without
changing the cartridge. If you select Continue, the
printer keeps printing but the printing quality cannot