Dell PowerVault 132T LTO/SDLT (Tape Library) - Manual (Page 25)

4. Slide the new RMU into position and tighten the thumbscrew ( Figure 11 ).
Figure 11. RMU module installation
5. Plug the power cable into a grounded electrical outlet.
6. Power on the library.
The library will detect the presence of the RMU. If you want to set a new IP Address, Subnet Mask, and Gateway Address, go to the Setup Wizard or Configure
RMU .
Installing/Replacing the Storage Networking Controller
1. Remove the SNC from the packaging.
2. Power down your library and disconnect the power cable from the electrical outlet.
3. From the back of the library, locate the available SNC slot. Loosen the four thumbscrews on the cover plate and remove the cover plate ( Figure 12 ).
Figure 12. SNC cover plate removal
4. Slide the SNC into position and until it mates with the connector then tighten the thumbscrews ( Figure 13 ).
Figure 13. SNC installation
5. Plug the power cable into a grounded electrical outlet.
Refer to the PowerVault 132T SNC User's Guide for more installation information.
Replacing the SNC
1. Power down your library and disconnect the power cable from the electrical outlet.
2. Remove the SNC from the library by loosening the thumbscrews and pulling out the SNC.