Dell PowerVault 132T LTO/SDLT (Tape Library) - Manual (Page 39)

Configuring Slots
Configure Slots allows you to set up specific slots of your library to be allocated for various functions, such as cleaning and partitioning.
Path:
the changes and move to the next option.
Step 37 Press and to
enable/disable the barcode scanner.
Available options are:
l on: all media will be scanned for
barcodes. Unlabeled or unreadable
labeled media will generate a user
message
l off: barcode scanner is disabled
Step 40 Press and then to accept
the changes and move to the next option.
Step 41 Press and to select the
barcode scanner mode.
Available options are:
l Default: The scanner will expect to read
and will report to the host six characters.
Optional one or two character media
identifiers can be present but will not be
reported. If you plan to use backup
software to manage media based on the
media identifier, this setting will need to
be changed either to Media ID or
Extended.
l Media ID: The scanner will expect to
read and will report to the host seven or
eight characters (six plus the media
identifier).
l Extended: The scanner will read and
report to the host between five and
sixteen characters.
Step 42 Press and then to accept
the changes and move to the next option.
Step 43 Set the IP Address by pressing
and to change the value of the current
field and and to move between
fields.
The IP Address, Subnet Mask, and Gateway
options are only present if a RMU is installed.
These items set up the network configuration
of the RMU.
The current field will be highlighted. Make sure
you enter a valid number for each field.
Step 44 Set the Subnet mask by pressing
and to change the value of the
current field and and to move
between fields.
The current field will be highlighted. Make sure
you enter a valid number for each field.
Step 45 Set the Gateway by pressing
and to change the value of the current
field and and to move between
fields.
The current field will be highlighted. Make sure
you enter a valid number for each field.
Step 46 From the last field of the Gateway
address, press to set the Gateway
mask and highlight Run ( ).
Step 47 You have now completed the
Setup Wizard. Press to accept all
values and exit the wizard.
Step 48 Press to exit the wizard.