Dell PowerVault 132T LTO/SDLT (Tape Library) - Manual (Page 45)

Fibre Setup
Fibre Setup allows you to set adjust settings for fibre drives. You can set the Loop ID, the drive speed, and the topology of the connection. This feature is not
available for libraries with SDLT drives.
Step 4 Press to highlight Run ( ) and
then press .
Step 5 A confirmation screen displays. Press
to dismiss.
Selection Description/Result
Step 1 From the Setup menu, highlight
and press .
Step 2 Highlight and press .
Sets Fibre Channel parameters.
Step 3 Press and to select the drive
for which you want to adjust the settings.
Chooses Drive 1. If Drive 1 is not a fibre
drive, the configurable parameters area uses
the placeholder NA (not available).
Step 4 After you have selected a fibre drive,
press to move to the configurable
parameters area. The first parameter is Loop
ID.
Step 5 Press to move to the Loop ID
values. Press and until the Loop ID you
want to use is displayed.
Sets the Loop ID.
For Loop ID you must choose a number
between 0 and 127.
Step 6 Press to move to the parameters
area. Press to get Speed.
Step 7 Press to move to the speed
values. Press and to select the speed
you would like to set.
Sets the Fibre Channel speed.
Step 8 Press to move to the parameters
area. Press to get Topol (topology).
Step 9 Press to move to the topology
values. Press and to select the
topology you would like to set.
For topology, choose one of the following:
l Auto L: Auto-Configure, trying L-Port
first
l Auto N: Auto-Configure, trying N-Port
first
l N Port: Point-to-Point
l L Port: Loop
Step 10 Press to highlight Run ( ) and
The fibre setup is complete.