Idrac6 express card, Removing an idrac6 express card – Dell DR4000 User Manual
Page 90
90
Installing System Components
10 Replace the expansion card. See "Installing an Expansion Card" on
11 Close the system. See "Closing the System" on page 61.
12 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
iDRAC6 Express Card
Removing an iDRAC6 Express Card
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 60.
3 Pull back slightly on the retention standoff tab at the front edge
of the card and gently lift the card off the retention standoff.
See Figure 3-16.
As the holder releases from the standoff, the connector under the card
disengages from the system board connector.
4 Angle the card so that the notch on the card slips through the clip on the
system board.
5 Replace the expansion cards. See "Installing an Expansion Card" on
6 Close the system. See "Closing the System" on page 61.
7 Reconnect the system and peripherals to their power sources, and turn
them on.
book.book Page 90 Friday, January 6, 2012 2:11 PM