Dell SP2008WFP Monitor - Manual (Page 28)

Product Specific Problemss
USB Problems
Troubleshooting Your Soundbar
NOTE: Image Burn-in is not covered by your warranty.
Camera / MIC Problems Camera / MIC not working l Ensure the USB upstream cable is connected to the PC.
l Install the Camera / MIC driver provided in the CD.
SPECIFIC SYMPTOMS WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS
Screen image is too small Image is centered on screen, but does not fill
entire viewing area. l Perform monitor reset on "All Settings.".
Cannot adjust the monitor with the
buttons on the front panel OSD does not appear on the screen. l Turn off the monitor, unplug the power cord and then plug
back and turn on the monitor.
SPECIFIC SYMPTOMS WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS
USB interface is not working USB peripherals are not working. l Check that your monitor is turned ON.
l Reconnect the upstream cable to your computer.
l Reconnect the USB peripherals (downstream
connector).
l Switch off and then turn on the monitor again.
High Speed USB 2.0 interface is
slow High Speed USB 2.0 peripherals working slowly or not at
all. l Check that your computer is USB 2.0 capable.
l Verify USB 2.0 source on your computer.
l Reconnect the upstream cable to your computer.
l Reconnect the USB peripherals (downstream
connector).
COMMON
SYMPTOMS
WHAT YOU EXPERIENCE POSSIBLE SOLUTIONS
No Sound No power to Soundbar - the
power indicator is off.
(built-in DC power supply. i.e.
SP2008WFP ) l Turn the Power/Volume knob on the Soundbar clockwise to the middle position; check if the
power indicator (blue LED) on the front of the Soundbar is illuminated.
l Confirm that the power cable from the Soundbar is plugged into the monitor.
l Confirm that the monitor has power.
l If the monitor has no power, see Troubleshooting your monitor for monitor common problem.
No Sound Soundbar has power - power
indicator is on. l Plug the audio line-in cable into the computer's audio out jack.
l Set all Windows volume controls to their maximum.
l Play some audio content on the computer (i.e. audio CD, or MP3).
l Turn the Power/Volume knob on the Soundbar clockwise to a higher volume setting.
l Clean and reseat the audio line-in plug.
l Test the Soundbar using another audio source (i.e. portable CD player).
Distorted Sound Computer's sound card is used as
the audio source. l Clear any obstructions between the Soundbar and the user.
l Confirm that the audio line-in plug is completely inserted into the jack of the sound card.
l Set all Windows volume controls to their midpoints.
l Decrease the volume of the audio application.
l Turn the Power/Volume knob on the Soundbar counter-clockwise to a lower volume setting.
l Clean and reseat the audio line-in plug.
l Troubleshoot the computer's sound card.
l Test the Soundbar using another audio source (i.e. portable CD player).
Distorted Sound Other audio source is used. l Clear any obstructions between the Soundbar and the user.
l Confirm that the audio line-in plug is completely inserted into the jack of the audio source.
l Decrease the volume of the audio source.
l Turn the Power/Volume knob on the Soundbar counter-clockwise to a lower volume setting.
l Clean and reseat the audio line-in plug.
Unbalanced Sound
Output Sound from only one side of
Soundbar. l Clear any obstructions between the Soundbar and the user.
l Confirm that the audio line-in plug is completely inserted into the jack of the sound card or
audio source.
l Set all Windows audio balance controls (L-R) to their midpoints.
l Clean and reseat the audio line-in plug.
l Troubleshoot the computer's sound card.
l Test the Soundbar using another audio source (i.e. portable CD player).
Low Volume Volume is too low. l Clear any obstructions between the Soundbar and the user.
l Turn the Power/Volume knob on the Soundbar clockwise to the maximum volume setting.
l Set all Windows volume controls to their maximum.
l Increase the volume of the audio application.
l Test the Soundbar using another audio source (i.e. portable CD player).