Plug and play capability, General, Flat panel – Dell SP2008WFP Monitor User Manual

Page 6: Webcam - mic specifications, Webcam - mic system requirements

Advertising
background image

l

1 upstream - rear

l

4 downstream - 2 on rear; 2 on left side

Plug and Play Capability

You can install the monitor in any Plug and Play-compatible system. The monitor automatically provides the computer system with its Extended Display
Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. Most monitor
installations are automatic; you can select different settings, if desired.

NOTE: USB 2.0 capability requires 2.0-capable computer.  

NOTE: The USB interface of the monitor works ONLY when monitor is powered ON (or in Power Save Mode). Switching your monitor OFF and then ON
would re-enumerate its USB interface; attached peripherals may take a few seconds to resume normal functionality.

 

General

Model number

SP2008WFP

Flat Panel

Screen type

Active matrix - TFT LCD

Screen dimensions

20.1 inches (20.1-inch viewable image size)

Preset display area:

Horizontal

433.44 mm (17.06 inches)

Vertical

270.9 mm (10.67 inches)

Pixel pitch

0.258 mm

Viewing angle

160° (vertical) typ, 160° (horizontal) typ

Luminance output

300 CD/m ²(typ)

Dynamic contrast ratio

2000 to 1 (typ)

Faceplate coating

ARC-Glare (2H)

Backlight

CCFL (4) edgelight system

Response Time

2ms typical (Grey to Grey)

Webcam - MIC Specifications

Lens

Field of view

66.5 degree +/- 5 %

Focus mode

Fixed Focus  

Focus area

49cm~Infinity

Focusing
distance (normal 
mode)

1100 mm

Image Sensor

Active array size 2.0 mega-pixel

Video specification

Video frame rate 1600 x 1200 (UXGA) - up to 10 frames per second

640 x 480 (VGA) and below - up to 30 frames per second

Image flip

Horizontally

Digital zoom

2x

Audio Specification

Microphone type Dual Microphone

Interface

USB 2.0 high Speed

Power Supply

5.0 volts+- 5%

Webcam - MIC System Requirements

The following are the minimum system requirements for Webcam - MIC feature:

Intel

®

Pentium

®

4 or AMD

®

equivalent processor running at 1.8 GHz or higher (Recommended: Intel Pentium 4, 2.8 GHz with Hyper-Threading enabled)

Microsoft

®

Windows

®

XP Service Pack 2 or Windows Vista

256 MB RAM (512 MB RAM or higher recommended)

580 MB free hard disk space

Advertising