Dell Inspiron 14R (N4110, Early 2011) - Manual (Page 41)

Power Button Board 41
10
Power Button Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 15) before working inside the computer.
Removing the Power Button Board
1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the battery (see "Removing the Battery" on page 15).
3 Remove the module cover (see "Removing the Module Cover" on
page 17).
4 Follow the instructions from step 4 to step 5 in "Removing the Optical
Drive" on page 19.
5 Remove the keyboard (see "Removing the Keyboard" on page 27).
6 Remove the palm-rest assembly (see "Removing the Palm-Rest Assembly"
on page 31).
7 Turn the palm-rest assembly over.
8 Remove the power-button board cable from the slot on the palm-rest
assembly.
9 Remove the screw that secures the power button board to the palm-rest
assembly.