Dell Inspiron 14R (N4110, Early 2011) - Manual (Page 65)

Camera Module 65
14
Camera Module
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 15) before working inside the computer.
Removing the Camera Module
1 Follow the instructions in "Before You Begin" on page 9.
2 Remove the battery (see "Removing the Battery" on page 15).
3 Remove the module cover (see "Removing the Module Cover" on
page 17).
4 Follow the instructions from step 4 to step 5 in "Removing the Optical
Drive" on page 19.
5 Remove the keyboard (see "Removing the Keyboard" on page 27).
6 Remove the palm-rest assembly (see "Removing the Palm-Rest Assembly"
on page 31).
7 Remove the display assembly (see "Removing the Display Assembly" on
page 53).
8 Remove the display bezel (see "Removing the Display Bezel" on page 57).
9 Using a plastic scribe, pry the camera module from the display back cover.
10 Lift the camera and remove the tape that secures the camera cable to the
camera module.
11 Disconnect the camera cable from the connector on the camera module.