Dell KVM 4322DS - Manual (Page 14)

4 xxx | Product Overview xxx
NOTE: To open a virtual media or smart card session with a target device,
you must first connect the target device to a switch using a SIP.
On-board Web Interface
The OBWI provides similar management functions as the RCS software, but
does not require a software server or any installation. The OBWI is launched
directly from the switch, and any servers connected to the RCS are
automatically detected. You can use the OBWI to configure the RCS from a
web browser. Launch the Viewer from the OBWI to establish KVM and virtual
media sessions to target devices. The OBWI also supports LDAP
authentication, which allows permissions for multiple RCSs to be managed
through a single interface.
Access the Switch Using a Standard TCP/IP Network
The switch provides agentless remote control and access. No special software or
drivers are required on the attached servers or client.
NOTE: The client connects to the switch using an Internet browser.
You can access the switch and all attached systems via Ethernet or using a V.34,
V.90, or V.92 modem from a client. The clients can be located anywhere a valid
network connection exists.
Encryption
The RCS supports 128-bit SSL(ARCFOUR), as well as AES, DES, and 3DES
encryption of keyboard/mouse, video, and virtual media sessions.
Video
The RCS provides optimal resolution for analog VGA, SVGA, and XGA video.
You can achieve resolutions up to 1600 x 1200 or 1680 x 1050 (widescreen),
depending on the length of cable separating your switch and servers.