Dell KVM 4322DS - Manual (Page 62)

52 xxx | Local and Remote Configuration xxx
RCS Tools
From the Tools - Maintenance - Overview screen, you can view the appliance
name and type. You can also perform basic appliance tasks.
Rebooting the RCS
To reboot the RCS:
1 From the side navigation bar, select the Unit View - RCS - Tools -
Maintenance - Overview tab to open the Unit Maintenance screen.
2 Click Reboot.
3 A dialog box appears, warning you that all active sessions will be
disconnected. Click OK.
NOTE: If you are using the local UI, the screen will be blank while the switch
reboots. If you are using the remote OBWI, a message will appear to let you
know that the interface is waiting on the appliance to complete the reboot.
Upgrading RCS Firmware
You can update your RCS with the latest firmware available.
After the Flash memory is reprogrammed with the upgrade, the switch performs
a soft reset, which terminates all SIP sessions. A target device experiencing a SIP
firmware update may not display, or may display as disconnected. The target
device will appear normally when the Flash update is completed.
Attention: Disconnecting a SIP during a firmware update or cycling power to
the target device will render the module inoperable and require the SIP to be
returned to the factory for repair.
To upgrade the switch firmware:
1 From the side navigation bar, select the Unit View - RCS - Tools -
Maintenance - Upgrade tab to open the Upgrade RCS Firmware window.
2 Click Upgrade to open the Upgrade Appliance Firmware.