Dell PowerVault MD3200 - Manual (Page 72)

72 Appendix—Manual Configuration of iSCSI
PersistentLoginTarget does not initiate a login to the target until after the
system is rebooted. To establish immediate login to the target, substitute
LoginTarget for PersistentLoginTarget.
: NOTE: See the Microsoft iSCSI Software Initiator 2.x User’s Guide for more
information about the commands used in the previous steps. For more information
about Windows Server 2008 Server Core, see the Microsoft Developers Network
(MSDN) at microsoft.com.
If you are using a Linux Server:
In MDSM, the Configure iSCSI Host Ports displays the status of each iSCSI
port you attempt to connect and the configuration state of all IP addresses. If
either displays Disconnected or Unconfigured, respectively, check the
following and repeat the iSCSI configuration steps:
• Are all cables securely attached to each port on the host server and storage
array?
• Is TCP/IP correctly configured on all target host ports?
• Is CHAP set up correctly on both the host server and the storage array?
To review optimal network setup and configuration settings, see "Configuring
iSCSI on Your Storage Array" on page 35.
Step 8: (Optional) Set Up In-Band Management
Out-of-band management (see "Step 1: Discover the Storage Array (Out-of-
band Management Only)" on page 54) is the recommended method for
managing the storage array. However, to optionally set up in-band
management, follow the procedure given below.
The default iSCSI host port IPv4 addresses are shown below for reference:
Controller 0, Port 0: IP: 192.168.130.101 Controller 0, Port 1: IP:
192.168.131.101
Controller 0, Port 0: IP: 192.168.132.101 Controller 0, Port 1: IP:
192.168.133.101
Controller 1, Port 0: IP: 192.168.130.102 Controller 1, Port 1: IP:
192.168.131.102
Controller 1, Port 0: IP: 192.168.132.102 Controller 1, Port 1: IP:
192.168.133.102
book.book Page 72 Thursday, July 18, 2013 5:56 PM