Step 7: system setup – Dell Compellent Series 40 User Manual
Page 23
17
Configuring a System via the Startup Wizard
Step 7: System Setup
The System Setup step allows you to set the System Name and Management IP
Address for the Storage Center.
Figure 11. System Setup
1 Enter the following:
•
Enter a System Name for the Storage Center.
•
(Dual-controller systems only) Enter the Management IP Address specified in
the pre-installation document. (On single-controller systems, this field is not
displayed and the message at the top of the dialog is slightly different.)
Note
The Management IP Address is distinct from the leader and peer controller
addresses. It is the address that manages a clustered-controller system. If the leader
or peer controller fails, the Management IP Address remains valid.
2 Click Continue. The dialog appears allowing you to enable or disable cache.