Dell OptiPlex GX1 User Manual
Page 133
Messages and Codes: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
file:///C|/infodev/2013/eDoc/OpGX1/UG/messages.htm[2/21/2013 11:47:24 AM]
Memory address line failure at
address, read value expecting
value
One or more DIMMs may
be faulty or improperly
seated.
See "
Memory allocation error
The software you are
attempting to run is
conflicting with the
operating system or
another application
program or utility.
Turn off the computer, wait 30
seconds, and then turn it on. Try
to run the program again. If the
problem persists, contact the
software company.
Memory data line failure at
address, read value expecting
value
Memory double word logic failure
at address, read value
expecting value
Memory odd/even logic failure at
address, read value expecting
value
Memory write/read failure at
address, read value expecting
value
One or more DIMMs may
be faulty or improperly
seated.
See "
Memory size in CMOS invalid
The amount of memory
recorded in the system
configuration information
does not match the
memory installed in the
computer.
Reboot the computer. If the error
appears again, see "
" for instructions on obtaining
technical assistance.
Memory tests terminated by
keystroke
The memory test did not
complete.
Rerun the memory test.
No boot device available
The computer cannot find
the diskette or hard-disk
drive.
Enter the
,
check the system configuration
information for the diskette and
hard-disk drive, and if necessary,
correct the information.
No boot sector on hard-disk
drive
The system configuration
information in System
Setup may be incorrect,
or the operating system
may be corrupted.
Enter the
,
check the system configuration
information for the hard-disk
drive, and if necessary, correct
the information.
If the message persists, reinstall
your operating system. See the
documentation that came with
your operating system.
No timer tick interrupt
A chip on the system
board might be
malfunctioning.
in the Dell Diagnostics.