Dell OptiPlex GX1 - Manual (Page 17)

Setup and Operation: Dell OptiPlex GX1 Small-Form-Factor System User's Guide
file:///C|/infodev/2013/eDoc/OpGX1/UG/setup.htm[2/21/2013 11:47:10 AM]
Table 2. Power Button Behavior Under Microsoft Windows 95 and Windows 98 (With Dell
AutoShutdown Loaded)
Action Results
System Turned On System in Suspend
Mode System Turned Off
Press power button System turns off System turns off Boots and system turns
on
Hold power button for 6
seconds* System turns off
immediately System turns off
immediately Boots and system turns
on
* Pressing or holding the power button to shut down the system may result in data loss. Use the power
button to shut down the system only if the operating system is not responding.
Table 3 shows power button functions for Microsoft Windows NT® operating systems.
Table 3. Power Button Behavior Under Microsoft Windows NT (With Dell AutoShutdown Loaded)
Action Results
System Turned On System Turned Off
Press power button System shuts down Boots and system turns on
Hold power button for 6 seconds* System turns off immediately Boots and system turns on
* Pressing or holding the power button to shut down the system may result in data loss. Use the power
button to shut down the system only if the operating system is not responding.
If the system does not turn off when you press the power button, the system may be hung. Press and hold
the power button until the system turns off completely (this process may take several seconds). Alternatively,
press the reset button to reset the system and reboot. If the system is hung and both buttons fail to function
properly, unplug the AC power cable from the computer, wait for it to completely stop running, plug in the AC
power cable, and if it the system does not restart, press the power button to restart the system.
Diskette-Drive Access Indicator
The diskette-drive access indicator lights up when the drive is reading data from or writing data to a diskette.
Wait until the access indicator turns off before removing a diskette from the drive.
Chassis Intrusion
An integrated chassis intrusion alarm displays the status of the system chassis intrusion monitor. If the
chassis has been opened, the setting changes to Detected and the following message is displayed during
the boot sequence at system start-up:
Alert! Cover was previously removed.