Dell Dimension L___cx - Manual (Page 121)

support.dell.com System Setup Program B-7
Peripheral Configuration Submenu
Figure B-4. Peripheral Configuration Submenu
Table B-5. Peripheral Configuration Submenu Options
Option Function
Serial port A Configures the serial port. Set this option to Auto (default),
Enabled, or Disabled. If set to Enabled, you can set the fol-
lowing additional options:
Base I/O O
Address
Available base I/O addresses are 3F8, 3E8, 2F8, and 2E8.
Interrupt Available interrupts are IRQ3 RQ3 and IRQ4.
Parallel port Configures the parallel port. Set this option to Auto (default),
Enabled, or Disabled. Depending on the port setting, you
can set the following additional options:
Mode If Parallel Port is set to Auto or Enabled, available modes
are Output Only, Bi-Directional (default), ECP, and EPP.
NOTE: Refer to the device manufacturer's documentation
for information on which mode to use before changing this
before changing this
setting.
Base I/O
Address If port is set to Enabled, available base I/O addresses are
378 (default), 278, and 228.
Interrupt If port is set to Enabled, available interrupts are 7 and 5.
NOTE: The Glossary in the system Help defines abbreviations and acronyms.