Dell Dimension L___cx - Manual (Page 135)

support.dell.com Diagnostic Codes, Beep Codes, and System Messages C-3 3
Recovery mode from
BIOS failure. Set the configuration jumper to
Maintenance mode (see
(see
Table 2-2), and restart the sys-
tem. Exit and save changes in
the system setup program. Turn
off the computer, reset the con-
figuration jumper to Normal
mode, and then restart the
system.
Remove all expansion cards and
restart the system to determine
if a resource conflict exists. If a
conflict exists, resolve the con-
flict as described in “Resolving
Software and Hardware Incom-
ware and Hardware Incom-
patibilities” in Chapter 5. If the
problem persists, refer to
Chapter 7, “Getting Help,” for
instructions on obtaining techni-
cal assistance.
Microprocessor has
failed a BIOS test.
OS test.
Refer to Chapter 7, "Getting
Help," for instructions on obtain-
ing technical assistance.
Memory failed to be d to be
sized or enabled.
Reseat the DIMMs as described
in “Reseating DIMMs” in
Chapter 6. If the problem per-
sists, refer to Chapter 7, “Getting
Help,” for instructions on
obtaining technical assistance.
Table C-1. Diagnostic Codes (continued)
Diagnostic Code Definition Corrective Action
NOTE: The Glossary in the system Help defines abbreviations and acronyms.
A B C D
A B C D
A B C D