Dell Vostro 1310 (Early 2008) - Manual (Page 12)

Back to Contents Page
Processor Thermal-Cooling Assembly
Service Manual
Removing the Processor Thermal-Cooling Assembly
Replacing the Processor Thermal-Cooling Assembly
Removing the Processor Thermal-Cooling Assembly
1. Follow the instructions in Before Working on Your Computer .
2. Remove the M2.5 x 5-mm screw that secures the memory cover.
3. Remove the cover and set it aside.
4. Remove the fan (see Removing the Fan ).
5. In sequential order, loosen the four captive screws that secure the processor thermal-cooling assembly to the system board, and carefully lift the
processor thermal-cooling assembly out of the computer.
Replacing the Processor Thermal-Cooling Assembly
1. Align the four captive screws on the processor thermal-cooling assembly with the screw holes on the system board and secure the screws.
2. Replace the fan (see Replacing the Fan ).
3. In sequential order, tighten the four captive screws to secure the processor thermal-cooling assembly to the system board.
4. Replace the memory cover.
Back to Contents Page
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
1 processor thermal-cooling assembly 2 captive screws (4)
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
NOTE: This procedure assumes that you have completed the removal procedure first.