Hard drives, Removing a 2.5-inch hard drive – Dell PowerEdge C5220 User Manual
Page 69
Installing System Components
69
Hard Drives
The following are examples showing the installation and removal procedures
for the 2.5-inch and the 3.5-inch hard drives.
Removing a 2.5-inch Hard Drive
NOTE:
Mixing SATA and SAS hard drive on the 2.5 and 3.5-inch hard drive board is
not supported.
1 Remove the sled from the system. See "Sled Configuration" on page 61.
2 Remove the hard drive from the sled docking bay.
3 Select the hard drive to replace and remove the four hard drive bracket
screws securing it underneath the sled.
4 Remove the hard drive from the sled docking bay.
CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
Bottom of sled
Top of sled