Dell XPS/Dimension XPS Gen 5 - Manual (Page 101)

Removing and Installing Parts
101
Installing a Floppy Drive
1 Follow the procedures in "Before You Begin" on page 69.
2 If you are replacing a drive and the new drive does not have the bracket rails attached, remove
the rails from the old drive by removing the two screws that secure each rail to the drive. Attach
the bracket to the new drive by aligning the screw holes on the drive with the screw holes on the
bracket rails and then inserting and tightening all four screws (two screws on each rail).
3 Gently slide the drive into place until the tabs securely click into position.
drive
screws (4)
bracket rails (2)
D8659bk0.book Page 101 Thursday, March 10, 2005 10:18 AM