Dell XPS/Dimension XPS Gen 5 - Manual (Page 43)

Solving Problems
43
IEEE 1394 Device Problems
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
N ON - SYSTEM DISK ERROR — Remove the floppy disk from the drive and restart your computer.
N OT ENOUGH MEMORY OR RESOURCES . C LOSE SOME PROGRAMS AND TRY AGAIN — Close all
windows and open the program that you want to use. In some cases, you might have to restart your
computer to restore computer resources. If so, run the program that you want to use first.
O PERATING SYSTEM NOT FOUND — Contact Dell (see page 139).
E NSURE THAT THE CABLE FOR THE I E E E 1 3 9 4 DEVICE IS PROPERLY INSERTED INTO THE DEVICE AND
INTO THE CONNECTOR ON THE COMPUTER
E NSURE THAT THE I E E E 1 3 9 4 DEVICE IS ENABLED WITHIN SYSTEM SETUP — See page 129.
E NSURE THAT THE I E E E 1 3 9 4 DEVICE IS RECOGNIZED BY W INDOWS —
1 Click the Start button and click Control Panel.
2 Click Printers and Other Hardware.
If your IEEE 1394 device is listed, Windows recognizes the device.
I F YOU HAVE PROBLEMS WITH A D ELL I E E E 1 3 9 4 DEVICE — Contact Dell (see page 139).
I F YOU HAVE PROBLEMS WITH AN I E E E 1 3 9 4 DEVICE NOT PROVIDED BY D ELL — Contact the
IEEE 1394 device manufacturer.
D8659bk0.book Page 43 Thursday, March 10, 2005 10:18 AM