Camera module, Removing the camera module – Dell Inspiron 14R (N4010, Early 2010) User Manual
Page 10
Back to Contents Page
Camera Module
Dell™ Inspiron™ N4010 Service Manual
Removing the Camera Module
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Follow the instructions from
step 3
to
step 4
in
Removing the Optical Drive
.
4.
Remove the module cover (see
Removing the Module Cover
).
5.
Remove the memory module(s) (see
Removing the Memory Module(s)
).
6.
Remove the keyboard (see
Removing the Keyboard
).
7.
Remove the palm rest (see
Removing the Palm Rest
).
8.
Remove the display assembly (see
Removing the Display Assembly
).
9.
Remove the display bezel (see
Removing the Display Bezel
).
10.
Remove the display panel (see
Removing the Display Panel
).
11.
Peel the camera module from the display cover.
12.
Lift the camera module and turn it over.
13.
Remove the tape that secures the camera cable to the connector on the camera module.
14.
Disconnect the camera cable from the connector on the camera module.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1 camera module
2 display cover
3 tape