Dell Dimension 5100 User Manual
Page 22
3.
Gently push the release tab on the card retention door from the inside to pivot the door open. Because the door is captive, it will remain in the open
position.
4.
If your computer includes a card retention mechanism, to secure the x16 card in place from the top:
a.
Pivot the mechanism upward and gently squeeze in on the sides to release the mechanism from the two tab slots holding it in place.
b.
Set the retention mechanism aside in a secure location.
5.
If you are installing a new card, remove the filler bracket to create a card-slot opening. Then continue with
.
6.
If you are replacing a card that is already installed in the computer, remove the card.
If necessary, disconnect any cables connected to the card. If your computer includes a card retention mechanism, remove the top of the retention
mechanism by pressing the tab and pulling up on the top. Gently pull the securing tab, grasp the card by its top corners, and then ease it out of its
connector.
7.
Prepare the card for installation.
See the documentation that came with the card for information on configuring the card, making internal connections, or otherwise customizing it for your
computer.
8.
If you are installing the card into the x16 card connector, position the card so the securing slot is aligned with the securing tab, and gently pull the
securing tab.
9.
Place the card in the connector and press down firmly. Ensure that the card is fully seated in the slot.
1 card retention door
2 card retention mechanism
3 release tabs (2)
1 securing tab
4 PCI Express x16 card slot
2 PCI Express x1 card
5 PCI Express x16 card
3 PCI Express x1 card slot
CAUTION:
Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be
sure to unplug your computer from its electrical outlet before installing any cards.
NOTICE:
Ensure that you release the securing tab to unseat the card. If the card is not removed correctly, the system board may be damaged.