Dell Dimension 5100 - Manual (Page 85)

Clearing CMOS Settings
1. Follow the procedures in " Before You Begin ."
2. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (RTCRST) on the system board .
b. Remove the jumper plug from pins 2 and 3.
c. Place the jumper plug on pins 1 and 2 and wait for approximately 5 seconds.
d. Replace the jumper plug on pins 2 and 3.
3. Close the computer cover .
4. Connect your computer and devices
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.