Dell Dimension 5100 - Manual (Page 36)

5. Slide the Media Card Reader into place until you feel a click or feel the drive securely installed.
6. Connect the FlexBay USB cable to the back of the Media Card Reader and to the Media Card Reader connector on the system board.
7. Route the FlexBay USB cable through the cable routing clip.
8. Replace the drive panel .
9. Replace the computer cover .
CD/DVD Drive
Removing a CD/DVD Drive
1. Follow the procedures in " Before You Begin ."
2. Remove the computer cover .
3. Remove the drive panel .
4. Disconnect the power and data cables from the back of the drive.
NOTE: Ensure that the Media Card Reader is installed before the FlexBay cable is connected.
1 Media Card Reader
2 FlexBay USB cable
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.