Replacing the display assembly – Dell Inspiron 17 (N7010, Mid 2010) User Manual
Page 24
12.
Lift and remove the display assembly off the alignment posts on the computer base.
Replacing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Align the display assembly with the alignment posts on the computer base.
3.
Replace the four screws that secure the display assembly to the computer base.
4.
Connect the display cable to the connector on the system board, and replace the display cable grounding screw.
5.
Connect the Mini-Card antenna cables to the connectors on the Mini- Card.
6.
Turn the computer over and replace the two screws that secure the display assembly to the computer base.
7.
Replace the palm rest (see
Replacing the Palm Rest
).
8.
Replace the keyboard (see
Replacing the Keyboard
).
9.
Follow the instructions from
step 5
to
step 7
in
Replacing the Hard Drive
.
10.
Replace the module cover (see
Replacing the Module Cover
).
11.
Replace the optical drive (see
Replacing the Optical Drive
).
12.
Replace the battery (see
Replacing the Battery
).
1 display assembly
2 screws (4)
3 display cable grounding
screw
4 display cable
connector
5 Mini-Card antenna cables
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.